Specification:

• Brand new

• Type: Co2 Adapter

• Material: Brass

• This easy to use Soda water Bottle Cylinder Filling Adaptor will enable you to fill your own CO2 from your larger bulk cylinder into smaller Soda water Bottle cylinders.

• An easy and inexpensive way to fill your own Soda water Bottle Cylinders at home at a fraction of the cost of getting the refills from your local store.

• Can be used with large co2 tanks with CGA320 connector(USA, CAN, Brazil, Colombia, Philippines...)

How it works:

• Step 1. Screw the adapter to a commercial CO2 gas cylinder

• Step 2. The empty CO2 cylinder is screwed into the adapter

• Step 3. Open the valve of the large gas bottle

• Step 4. After about 15-20 sec., The cylinder is completely filled

• Step 5. Close valve of the large gas bottle

• Step 6. Opening the bleed screw to drain residue remaining gas

• Step 7. Unscrew the CO2 cartridge – done

When using, be sure to following these important points:

• That the seals goes in the correct location. So when the Soda water Bottle Filling Adaptor arrives, please make sure to use the correct seal in the correct side.

• Make sure to put the Soda water Bottle cylinder on the correct side. The Soda water Bottle cylinder thread can actually fit both sides of this adaptor, but the CO2 cylinder only fit''s into the ROUND SIDE. As a result you MUST put the Soda water Bottle cylinder into the HEXAGONAL SIDE.

Package Included:

• 1 x Soda water Bottle Cylinder Refill Adapter